Some Issues To Watch Out For When Using Copper Piping
There are two forms of copper piping. There is rigid and there is flexible. The rigid form is what you will find in new homes and is neater to install, yet notably much more difficult than the flexible type. Flexible is best for repair work.
There’s three types of fittings involved in making your pipe. One type are the joints or pieces designed for making it branch off. Another type is for making your pieces bend and curve. Adaptors and couplings can be used to join two pieces together. Either type of piping can be used with these fittings.
When cutting the pipes, you are going to be using either a common hacksaw or a copper pipe cutter. The hacksaw will leave less burrs inside, making for easier cleanup. You are going to have to use a jig or a meter box to hold the piece steady while you cut. Use a wood block or board with a notch cut into it for this.
Be sure to clean up thoroughly if using the pipe cutting instrument. The inside of the pipe will be full of shavings, clear all of them out before proceeding. They can cause a lot of problems if not removed completely.
With your cut pipe, you are ready to work it into the design you need. Have all your tools ready, including your propane torch and all the fittings you will require. After you have cleaned the pipe and joints, apply your soldering paste. This is critical as it keeps the pipe from oxidizing during the heating process. Put the fitting on and solder it using your torch. Turn off your flame to apply the solder at the joining area. There should be easy flow into the fit. Melt the solder all the way until it is surrounds your fitting completely.
Do not overheat your copper piping during this process. Take care around the fittings as well. You may need to cover it with a wet towel to protect it when reheating any certain area.
Visit my site. We’ve got helpful articles about everything, from kitec pipes to Calcoast Re-Piping.